Fiamma MARINA Gebrauchsanweisung Seite 24

2.
In order to define the amount of coffee per dose, please proceed as follows:
1.
2.
This will turn on all the LED signal lamps.
3.
(for example: K1EXP). This will light up the associated LED signal
lamp (i.e. L1EXP). Also, the LED attributed to the confirmation
mode (LCONT) will light up. All other LED's will switch
themselves off.
4.
the respective dosage (i.e. K1EXP). Now, the associated LED signal
lamp will switch itself off and all others will light up.
To define the other dosages, repeat the same operation.
In order to leave the configuration mode, wait for 20 seconds.
3.
In order to clean the group with the washing function, please proceed as follows:
-
-
NOTE: It is not possible to interrupt the washing process. Therefore, you have to wait for the washing to finish
Downloaded from www.Manualslib.com
DOSAGE DEFINITION
Insert the desired dose(s) of coffee in the filter-holder and set it into the group.
Press the configuration key KCONT and keep pressing for 5 seconds.
Within the following 20 seconds, press any of the start/stop keys
When the desired coffee dose is reached, press the start/stop key for
WASHING THE GROUP
Put the blind filter into the filter-holder and fill it with a tea spoon of an adequate detergent for coffee
machines. Put the filter-holder into the group.
Make sure the machine is turned off. Press and hold the key K2EXP,
which will turn on the machine. Check whether the LED signal lamps
L1LUN and L2EXP are blinking to indicate that the washing process
has been initialized.
The washing process consists of 5 washing cycles.
Once the washing is finished, the system will automatically set itself to the ON position.
before you can prepare coffee again.
manuals search engine
5