System Reset - AXENT ONE Bedienungsanleitung

USE WITH REMOTE CONTROL
DECALCIFICATION OF THE WATER-BEARING PARTS
The entire water system can easily be decalcified like a coffee machine. Fill a cup with 200ml
decalcification liquid (Durgol preferred).
Press and hold [ 19 ] Setting and press [ 18 ] Spray arm cleaning to start the process.
The water system will be drained completely and the spray arm is moving out without any water spray
function.
– Hold the cup close the spray arm.
– Dip the spray arm into the cup with the decalcification liquid.
The liquid will be absorbed. The spray arm moves back into its position.
The decalcification liquid will circulate in the water-bearing parts in order to dissolve the limestone.
The decalcification liquid will be ejected automatically.
The whole water-bearing system will be rinsed 3 times with fresh water.
This process takes around 3 minutes and cannot be interrupted.
The night light flashes slowly during the entire process.
SYSTE M PU RG E
After a long time of not using the shower toilet, all water bearing parts can be flushed with fresh water.
Press [ 17 ] System purge to turn on the function.
The system purge process stops automatically after 90s.
Press [ 17 ] System purge again to immediately stop the system purge.
E M PT Y TH E WATE R TAN K
In case of a service intervention, you might be obliged to empty the water tank.
To start the procedure, press and hold [ 19 ] Setting and press [ 17 ] System purge.
The pump empties the water tank. You will hear a «beep» if the process is finished.
SYSTE M R ES ET
Switch off the remote control by pressing [ 19 ] Setting + [ 1 ] User simultaneously.
Press and hold the [22 ] Energy-saving mode and press [ 19 ] Setting.
The device sounds a long «beep».
The remote control is switched on. The device is restarted automatically.
All values are reset to factory settings.
21