Pair To The Receiver; Time Settings And Temperature Calibration - Sundirect Smart1.0Pro Handbuch

5.1 Pair to the receiver

All "Plus" range heaters have a built-in
thermostat receiver-Receiver01 on the
backside of the panel. On the right, see the
drawing of the signal lights and button of
Receiver01. The following is a detailed
description of the buttons and signal lights:
1.Pair status signal light (green light)
2.Heating status signal light (red light)
3."P" button
4. Power switch
Step1: Plug your heater to an electricity outlet, switch the Power switch
of Receiver01 on, double press the "P" button and the "Pair signal light"
will start to flash and is ready for pairing.
Step2: Power-off the Smart1.0Pro, long press the "SET" button. The
"PAIR" signal will show on the screen of the remote control. Wait until the
"Pair signal light" stops flashing and glows green to finish the pairing.
Note: Once Receiver01 and Smart1.0ProPro are paired, the pair signal
light will always be on and the Receiver01 will be only commanded by the
Smart1.0 Pro. One Receiver01 can only pair to one Smart1.0Pro,
however, one Smart1.0Pro can be paired to several Receiver01 if they are
in the same room.

5.2 Time settings and temperature calibration

Power on Smart1.0Pro. Press "SET" button for 5 seconds to enter the
settings. The screen on the thermostat will show as below and the
minutes of the timer setting will start to flash.
5