Stramatel SCX40 Autonom Technische Daten - Montageanleitung Seite 11

Outdoor
Installation on I-Beams - Before installation (for each display unit)
The electronic elements controlling the luminous display are mounted on extractable racks (R). In order to be able to carry out
any maintenance, a clear space of at least 30 cm is necessary for the extraction of the racks. Attention: installation must be
performed by qualified staff.
The display unit will be fixed onto 1 vertical 180x90mm I-Beam with supplied fixing clamps (D).
Insert 2 M10 spring nuts in each fastening rail (G).
Fix 2 clamps (D) on each fastening rail (G) as mentioned below. Tighten the screws (V), then unscrew them by quarter a turn
(as a first step, the clamps should not be fully tightened).
D
E
G
Installation on I-Beams - Display units installation (for each display unit)
In order to make the installation easier, the anchor points (I), located on the top side of the module can be used (NB: Anchor
points = insert holes in aluminium frame). If you want to use them to lift or install the module, replace the black plastic screws
by M6x40 eyescrews (closed rings, not supplied). Caution: the black plastic screws should not be used to lift or fix the module
(they are only dedicated to protect the scoreboard from water intrusion).
Lift the display unit and lean it against the vertical 180x90mm I-Beam. Make sure the scoreboard is in a horizontal position.
On each fastening rail, move the clamps as close to the I-beam as possible (the screws should imperatively touch the I-Beam
to make sure the clamps are properly fixed). Tighten the screws (V) on the fastening rails (G).
Tighten the lock nuts (E) to secure the clamps (D) on the I-Beam
Put the black plastic screws back into anchor points (I).
I
ZI de Bel Air 44850 LE CELLIER FRANCE
IASCX40A-IM_F - Installation SCX40A
V
1200
I
300
R
stramatel@stramatel.com Tél. +33 (0)2 40 25 46 90
Dimensions in mm
G
D
E
V
IPN
180x90
Page 3