Data Robotics Drobo FS Handbuch Seite 16

Your Drobo FS connects to a network using an Ethernet port. Use the
Ethernet connection on the back of the Drobo FS to connect to a router
or switch. Use the Ethernet cable included with the original Drobo FS.
Note: Drobo FS supports a gigabit (1000 Mbit/s) connection. It will auto-
negotiate the highest connection speed available to the router or switch. You
will not get optimal performance if you are using a slower connection (10/100
Mbit/s).
Once you have connected Drobo FS to your network, the next step is to
connect it to an AC power source. Simply connect the power cord to the
back of the Drobo FS and to your power source. Then press the toggle
power button on the back of the unit to turn your Drobo FS on.
Note: As with all electronic equipment, we recommend connecting your
Drobo FS to a surge protector or uninterruptible power supply (UPS), designed
for electronics.
Your Drobo FS is set to automatically obtain an IP address (DHCP) on
your network. When you connect Drobo FS to the network, Drobo
Dashboard will automatically discover it. After Drobo Dashboard
discovers your Drobo FS, you can set a static IP address if desired. If you
don't have DCHP and need to use a static IP address, you should directly
connect the Drobo FS to your computer's Ethernet connection for the
initial setup. See the section, "Tips and Troubleshooting" on page 21 for
further information on direct-connect and setting the IP address of your
Drobo FS.
7