Special Recommendations; Power Sources - COLUMBIA VAC OPC1050N Bedienungsanleitung

9. Electrical-equipment inspections
Repairs and maintenance of the electric components include preliminary safety inspections
and component-control procedures. In the instance of a fault which could risk safety, do not
connect the power supply to the circuit until it has been satisfactorily rectified. If the fault
cannot be rectified immediately, but further action is necessary, an appropriate temporary
solution must be implemented. This should be reported to the device owner so that all
parties are informed.
Preliminary safety inspections include
- condenser discharge: should be done in a safe way to avoid the possibility of sparking;
- no covering of live electrical components or wiring when charging, recovering, or
cleaning the system;
- earthing continuity

SPECIAL RECOMMENDATIONS:

- Ambient temperature range for the device is 5°C -35°C.
- Install the portable air dryer on a flat location with a large space, without obstacles.
Leave a 20cm minimum space between the unit and the wall.
- The device must be installed in accordance with national installation regulations.
- The plug shall be always accessible after its installation.
- Always place the appliance in a vertical position, in order to maintain the compressor
in good working condition.
- Do not tilt the device in any direction as spilled water can damage the device.
- Do not use the appliance near gas or other inflammable liquids.
- Do not block the air outlet and inlet ventilation. Do not place heavy objects on the
device.
- Do not use spray (insecticides, painting) or any other inflammable products near
the appliance as the plastic case may be deformed. The unit may sustain electrical
damage.

POWER SOURCES

- The plug has to be well fixed and should not be damaged.
- Do not plug in the appliance with an adaptor.
- Plug into the wall socket before switching on the appliance then press on the ON/OFF
button.
23