Team rc 6 Gebrauchsanleitung Seite 11

Fax +32 2 359 95 50

 For chopping, select speed 1 or 2. CAUTION: Do not try to chop very hard food (such as
ice, sugar or coffee grains...).
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
 The metal chopping blade is very sharp. You can use the plastic blade cover to store the
chopping blade in a safe way when you have cleaned it after use.
b) Whisking
Do not use the whisking blade to knead heavy dough such as tart pastry or pizza dough.
 Make sure that the appliance is unplugged and that the ON/OFF & speed switch is in "0"
position.
Place the processor bowl onto the shaft and make sure that the three squares on top of

the motor block fit into the three notches at the bottom of the bowl.
 For whisking, put the whisking blade on the support and place the blade support onto the
shaft.
 Put the ingredients into the bowl.
 Place the lid with feeding tube onto the processor bowl as indicated in paragraph "Use"
making sure the metal shaft of the blade support gets into the hole in the middle of the lid.
 This accessory can be used to whisk egg whites and prepare sauces like mayonnaise or
custard.
 Plug in the appliance and turn the ON/OFF & speed switch to speed 1 or 2.
 It is possible to add ingredients during process through the funnel of the lid.
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
c) Grating / Slicing
 Make sure that the appliance is unplugged and that the ON/OFF & speed switch is in "0"
position.
 Place the processor bowl onto the shaft and make sure that the three squares on top of
the motor block fit into the three notches at the bottom of the bowl.
 Slide the accessory for grating/slicing onto the support with the grating blade upwards for
grating or with the slicing blade upwards for slicing. Slide the three small pins of the support
into the foreseen holes in the accessory and turn the accessory clockwise until it locks into
place.
 Place the whole on the shaft.
 Place the lid with feeding tube onto the processor bowl as indicated in paragraph "Use"
making sure the metal shaft of the blade support gets into the hole in the middle of the lid.
 Cut the potatoes, carrots, cucumbers etc... into pieces and place the ingredients into the
funnel of the bowl lid.
 Use the pusher (6) to push food down the funnel. Never use your fingers or any other utensil.
 Plug in the appliance and turn the ON/OFF & speed switch to "1" to start. Adjust the
speed if necessary.
 Always turn the ON/OFF & speed switch to "0" and unplug the appliance before emptying
the bowl and be careful when handling the blades, as they are very sharp.
 When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
CLEANING
 Unplug the appliance.
 Turn the lid with feeding tube clockwise to take it off.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
11
Assembly page 11/36
special instruction from
TEAM RC 6 - 080519
Team