Team rc 6 Gebrauchsanleitung Seite 10

Fax +32 2 359 95 50

Never block the safety device of the appliance.

The processor bowl can simply be washed under running water.

Be careful not to hurt you when handling, removing, cleaning or emptying the bowl.

Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not designed for professional use. You should follow the requested breaks.
Failure to follow this instruction carefully may result in damage to the motor. Please refer to the
rating label for the maximum continuous usage time (KB xx min in which xx is the maximum
usage time). The breaks should last at least 10 minutes. Any wrong use will invalidate the
guarantee.
USE
Make sure the appliance is unplugged and the ON/OFF & speed switch (1) is in position "0".
 Place the processor bowl (4) onto the shaft and make sure that the three squares on top
of the motor block fit into the three notches at the bottom of the bowl.
 Make sure the bowl is well fitted, if not, the appliance will not work.
 Depending on the desired preparation, you will have to use various accessories. For more
details, please check the instructions below.
 Place the lid with feeding tube (5) on the bowl in such a way that the arrow  on the lid is
slightly to the left of the arrow  on the bowl and turn it anticlockwise until the arrow on
the lid ends up right above the arrow on the bowl. Caution: as long as the lid is not locked
properly, the appliance will not work.
 Plug in the appliance.
 Turn the ON/OFF & speed switch up to speed 1 or 2 depending on preparations.
 If you wish to use the appliance punctually, turn the ON/OFF & speed switch to position
"P" ("pulse") for one or two seconds. Do not use the pulse function for a longer time. When
you let the switch go, it will switch back to "0" automatically. The pulse function is perfect
for making milkshakes.
FUNCTIONS
a) Chopping
 Make sure that the appliance is unplugged and that the ON/OFF & speed switch is in "0"
position.
 Place the processor bowl onto the shaft and make sure that the three squares on top of
the motor block fit into the three notches at the bottom of the bowl.
 Remove the plastic blade cover of the chopping blade, put the chopping blade (9) on
the support (10) and check if the chopping blade has been firmly attached to the
support.
 Place the blade support with the chopping blade onto the shaft.
 Then put the ingredients into the bowl. We advise you to cut ingredients like meat or
vegetables into pieces beforehand in order to get a homogeneous preparation.
 Place the lid with feeding tube onto the processor bowl as indicated in paragraph "Use"
making sure the metal shaft of the blade support gets into the hole in the middle of the lid.
 Plug in the appliance.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
10
Assembly page 10/36
special instruction from
TEAM RC 6 - 080519
Team