Brush Heads - Braun Oral-B TRiZone 5000 Bedienungsanleitung

the gumline. Apply light pressure and start brushing
in back and forth motions. Brush first the outsides,
then the insides. Finally, brush the chewing surfaces
with the same back and forth motion throughout the
mouth (picture 3, page 5). Please ensure that you
brush all four quadrants of your mouth equally.
In the first days of using any electric toothbrush, your
gums may bleed slightly. In general, bleeding should
stop after a few days. Should it persist after 2 weeks,
please consult your dentist or dental hygienist. If you
have sensitive teeth and gums, Oral-B recommends
using the «Sensitive» mode optional in combination
with Oral-B «Sensitive» brush head.
Timer
You can choose between «Professional» or
«2-Minute» timer and «Count up» or «Count down»
timer.
The «2-Minute» timer signals with four beeps and a
Smiley on the SmartGuide that the dentist recom-
mended 2-minute brushing time has been reached.
In addition the «Professional» timer signals with short
beep sounds at 30-seconds intervals to move to the
next quadrant of your mouth (45 seconds intervals
within «Deep Clean» mode) (picture 3, page 5).
A single beep indicates completion of the first
quadrant, two beeps the second one, three beeps
the third one and four beeps sound when you reach
the recommended 2-minute brushing time (3-minute
brushing time within «Deep Clean» mode).
The timer memorizes the elapsed brushing time,
even when the handle is briefly switched off during
brushing. The timer resets if pausing longer than
30 seconds or briefly pressing the mode button (d)
during pause.
The «Count up» timer displays your actual brush-
ing time. The «Count down» timer indicates the
remaining brushing time.
Personalizing the timer
Your toothbrush comes with the «Professional» and
«Count up» timer activated. To change this, press
and hold the brushing mode button for 3 seconds
until the SmartGuide shows «:30» and «timer».
Briefly press the on/off button to switch to the
«2-Minute» timer. Push the mode button to confirm.
The SmartGuide now shows «up» and «timer». Press
the on/off button to switch to the «Count down»
timer and confirm with the mode button. Leave the
setup menu by pressing the mode button.
Pressure sensor
If you put excessive pressure on your teeth, the
red pressure sensor light (b) will light up (picture 3,
Downloaded from www.Manualslib.com manuals search engine
page 5). Additionally, when brushing in «Daily
Clean» or «Deep Clean» mode, the brushing mode
will change to the «Sensitive» mode. Periodically
check the operation of the pressure sensor by
pressing moderately on the brush head during use.
Brushing modes
Your toothbrush offers different brushing modes:
«Daily Clean» – Standard mode for daily
mouth cleaning
«Deep Clean» – Mouth cleaning with
extended brushing time of
45 seconds per quadrant
(3 minute total brushing time)
«Sensitive» – Gentle, yet thorough
cleaning for sensitive areas
«Whitening» – Polishing for occasional or
everyday use
«Massage» – Gentle massage of gums
Your toothbrush automatically starts in the «Daily
Clean» mode. To switch to the other modes, succes-
sively press the mode button (picture 4, page 5).
To return from any mode back to the «Daily Clean»
mode, press and hold the mode button.
The brushing mode is memorized even when the
handle is briefly switched off during brushing. When
pausing longer than 30 seconds or briefly pressing
the mode button (d) during pause the brushing
mode resets to the «Daily Clean» mode.

Brush heads

Oral-B TriZone brush head
features triple zone cleaning action
for outstanding plaque removal, even
in between teeth.
Oral-B also offers you a variety of different Oral-B
brush heads that fit your Oral-B toothbrush handle
and can be used for tooth-by-tooth precision
cleaning.
Oral-B FlossAction brush head
features micropulse bristles that allow
for an outstanding plaque removal in
the interdental areas.
Oral-B Precision Clean brush head
cups each tooth with a curved bristle
trim and reaches deep between teeth
at the same time.
13