ORFELD DX025A Bedienungsanleitung Seite 9

serviced at a ORFELD service center.
Lighting up the front lamp
1
1. Lamp
CAUTION:
or see the source of light directly.
Pull the switch trigger to light up the lamp.
The lamp keeps on lighting while the switch
trigger is being pulled.
NOTE: Use a dry cloth to wipe the dirt
off the lens of the lamp. Be careful not to
scratch the lens of lamp, or it may lower the
illumination.
Reversing switch action
A
1. Reversing switch lever
Do not look in the light
1
C A U T I O N :
direction of rotation before operation.
CAUTION:
switch only after the tool comes to a
complete stop. Changing the direction of
rotation before the tool stops may damage
the tool.
CAUTION:
the tool, always set the reversing switch
lever to the neutral position.
This tool has a reversing switch to change
the direction of rotation. Depress the
reversing switch lever from the A side for
clockwise rotation or from the B side for
coun- terclockwise rotation.
When the reversing switch lever is in the
neutral posi- tion, the switch trigger cannot
be pulled.
Speed change
1. Speed change lever
CAUTION:
change lever fully to the correct position.
If you operate the tool with the speed
B
change lever positioned halfway between
the "1" side and "2" side, the tool may be
damaged.
CAUTION:
change lever while the tool is running.
The tool may be damaged.
9
A l w a y s c h e c k t h e
Use the reversing
When not operating
1
Always set the speed
Do not use the speed