ORFELD DX025A Bedienungsanleitung Seite 12

CAUTION:
Pressing excessively on
the tool will not speed up the drilling. In
fact, this excessive pressure will only serve
to damage the tip of your drill bit, decrease
the tool performance and shorten the
service life of the tool.
CAUTION:
exert care when the drill bit begins to
break through the workpiece. There is a
tremendous force exerted on the tool/drill bit
at the time of hole break through.
CAUTION:
removed simply by setting the reversing
switch to reverse rotation in order to
back out. However, the tool may back out
abruptly if you do not hold it firmly.
C A U T I O N :
workpieces in a vise or similar hold-
down device.
CAUTION:
continuously until the battery cartridge
has discharged, allow the tool to rest
for 15 minutes before proceeding with a
fresh battery.
Using the tool a s a h and s crewdriver
Swich off the tool.
Move the reversing switch lever to the neutral
position Turn the adjusting ring so that the
arrow points to the marking.
Turn the tool.
Hold the tool firmly and
A stuck drill bit can be
A l w a y s s e c u r e
If the tool is operated
NOTE: This use is convenient for checking
the screwdriving.
NOTE: Do not use the tool for work requiring
exces-sive force, such as tightening bolt or
removing rusted screws.
Charging the battery
1. Open the dust cover, insert the charger
plug into the battery charge port.
2. Once charging commences, the Red
LED will on.
3. When the Battery is fully charged, the
Red LED will off and Green LED will on.
NOTE: Make sure the Battery and Battery
Charger are lined up correctly.If the Battery
does not slide on to the Battery Charger
easily, don't force it. Instead, remove
the Battery, check the top of Battery and
the Battery Charger slot are clean and
undamaged and that the contacts are not
bent.
12