ORFELD DX025A Bedienungsanleitung Seite 8

CAUTION:
battery cartridge fully. If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you.
CAUTION:
Do not install the battery
cartridge forcibly. If the cartridge does
not slide in easily, it is not being inserted
correctly.
Battery protection system
The tool is equipped with a battery protection
system. This system automatically cuts off
power to the motor to extend battery life.
The tool will automatically stop during
operation if the tool and/ or battery are
placed under one of the following conditions:
Overloaded:
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, turn the tool off and stop the
application that caused the tool to become
overloaded. Then turn the tool on to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before turning the tool on again.
Low battery voltage:
The remaining battery capacity is too low
and the tool will not operate. If you turn the
tool on, the motor runs again but stops soon.
In this situation, remove and recharge the
battery.
Indicating the remaining battery capacity
Only for battery cartridges with the
indicator
Always install the
1 2
1. Indicator lamps 2. Check button
Press the check button on the battery
cartridge to indi- cate the remaining battery
capacity. The Indicator lamps light up for a
few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use
and the ambient temperature, the indication
may differ slightly from the actual capacity.
Switch action
1
1. Switch trigger
CAUTION:
battery cartridge into the tool, always
check to see that the switch trigger
actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch
trigger. Tool speed is increased by increasing
pressure on the switch trigger. Release the
switch trigger to stop.
Electric brake
This tool is equipped with an electric brake. If
the tool consistently fails to quickly stop after
the switch trigger is released, have the tool
8
Remaining
capacity
66% to 100%
33% to 66%
0% to 33%
Before installing the