Vacuuming Dry Materials; Maintenance; Regular Inspection And Maintenance; After Using The Vacuum Cleaner - FIORENTINI K42 Bedienungsanleitung

EN
Check that the float system is working properly. In
particular, the float must slide freely inside the
guide basket. On machines equipped with a
cartridge filter, you must dismantle the filter to
access the float system.
The guide basket is wedged on the base, it can
therefore be dismantled easily without tools.
Always clean the float system after vacuuming
liquids.
Never vacuum liquids without the float
system in place and if it is not working
properly.
If foam forms while vacuuming liquids and starts
coming out of the vacuum cleaner head, stop all
operations immediately and disconnect the
machine from the electrical mains.
Always use a chemical anti-foaming agent
recommended by the detergent manufacturer.
Before emptying the container, disconnect the
vacuum cleaner from the power socket.
Disconnect the hose from the inlet nozzle by
pulling it outwards. Separate the vacuum cleaner
head from the drum. Empty the container by tilting
it backwards and pour the liquids into a floor drain
or similar.

4.2 Vacuuming dry materials

Remove the electric plug from the socket before
emptying the vacuum cleaner after vacuuming dry
materials.
Check the filters and dust collection bag regularly.
Release the locking device by pulling it outwards in
order to free the upper part of the machine. Open
the upper part of the motor from the container.
If a collection bag is used, check how full it is.
Replace the dust collection bag if necessary.
If the bag is not used, shake or brush the bag filter
or the cartridge filter.
After shaking: close the upper part of the machine
on the container and fasten it with the release
clips.
Never vacuum dry material without the
cartridge filter or bag filter (and possibly
the dust collection bag as well) mounted in
the appliance.
The vacuuming efficiency of the vacuum cleaner
depends on the size and quality of the filter and
8
CAUTION
CAUTION
dust collection bag, therefore only use original
filters and dust collection bags.

5 Maintenance

5.1 Regular inspection and maintenance

The appliance must be inspected and serviced
regularly by qualified staff in accordance with the
laws and regulations in force. In particular,
electrical tests for earth continuity, insulation
resistance and the conditions of the flexible cable
must be carried out frequently.
In the event that it is faulty, the appliance MUST be
put out of service, fully tested and repaired by an
authorised service technician.
5.2 Maintenance
Remove the plug from the socket before servicing
the appliance. Before using the appliance, make
sure that the frequency and voltage featured on
the plate correspond to the mains voltage.
The vacuum cleaner is designed for continuous
and heavy duty operation. The dust filter must be
replaced according to the hours of operation.
Keep the vacuum cleaner clean with a dry cloth
and a small amount of spray cleaner.
HAZARD
Do not wash the vacuum cleaner with a jet
of water, if water gets into the head it
could damage it and impair the safety of
the appliance.
For further details about the after-sales service,
contact your dealer or the Ing.O.Fiorentini S.p.A.
service representative. Refer to the last page of
this document.

6 After using the vacuum cleaner

6.1 After use

When the appliance is not being used, remove the
plug from the socket. Wind the cable starting from
the appliance.
The power cable can be wound into a spool and
hung at the back of the head. Some versions
feature compartments for storing accessories.

6.2 Transport

Before transporting the dirt collection tank, close all
the locking devices. Do not tilt the vacuum cleaner
if there is liquid in the dust collection tank. Do not
use a crane hook to lift the vacuum cleaner.

6.3 Storage

*Optional feature depending on the model.