3M Digital Media System 800-Serie Bedienungsanleitung Seite 6

Lamp Replacement
• To reduce the risk associated with hazardous voltage:
- Do not remove any screws other than those specified in the lamp
replacement instructions.
- Always plug projector into a grounded outlet.
- Do not use in wet environments.
- Do not use in an outdoor environment.
- Replace the power cord if damaged.
- Do not attempt to service the projector other than performing
routine lamp replacement. Service should only be performed by
a M authorized service provider. Aside from the projection lamp
module, there are no user serviceable parts inside the unit.
- Do not modify this projector or power cord.
- Disconnect power cord when the projector is not in use, during lamp
replacement, and while cleaning.
- Do not allow water or other liquids to enter the projector.
• To reduce the risk associated with hazardous voltage and/or fire:
- Use a properly rated extension cord. Consult an electrical
professional if you have questions.
• To reduce the risk associated with hot surface of lamp cartridge:
- Wait at least 60 minutes for the lamp assembly to cool before
replacing.
• To reduce the risk associated with choking:
- Keep batteries away from children and pets.
6
M Digital Media System 800 Series
™
m� W ARNING
© M 2006. All Rights Reserved.