Weidmuller WAVESERIES PT 100/4 Beipackinformation Seite 23

3.2 Pluggable electronic components for range alteration
(depending on model)
(Page 94, Figure 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one position.
The connectors have been coded by the manufactur-
er, ensuring that they cannot be reversed.
3.3 Setting the potentiometer (depending on model)
(Page 95, Figure 3)
The module has been exactly calibrated by the manufacturer.
Should nevertheless a follow-up adjustment be necessary, open
the hinged cover upwards.
The potentiometers are on the front panel.
23