Weidmuller WAVESERIES PT 100/4 Beipackinformation Seite 22

1 General instructions
The WAVESERIES signal conditioner PT 100 should only be
installed by qualified staff. The signal conditioner PT 100 should
only be powered up following professional installation.
2 Application
The WAVESERIES signal conditioner PT 100 can be used to
connect PT 100 sensors as well as converting temperature data
into standard linear current signals. The temperature range can
be set by DIP switches on the printed circuit board.
The signal conditioner PT 100/4 can be connected to 2-, 3- and
4-wire temperature sensors.
3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
3.1 Mounting onto TS 35 DIN rails
(Page 94, Figure 1)
22