External Control - AquaForte Vario+ 1100 Bedienungsanleitung

Step2: Use or
To move cursor to next setting. Press
Choose a speed range for timer 1, use
to decide on a specific speed if needed.
Step3: Repeat above steps to set other 3 timers
Step4: Hold for 3 seconds or wait 10 seconds to save
setting automatically.
A flashing
Step5: press or
*
Overlap setting of time will be considered as invalid , the device will only run based on
previous valid setting.
* During timer setting, if you want to abandon it, hold
Note:
*
If inactivate in 1 minute, the screen will lock automatically. Hold
the device.
* The device has power-off memory, operation will resume upon power restoration.
* Under OFF mode, hold

5.4 External control

External control can be enabled via the following contacts. However even if it's working via
external control, Press
E.g.: To enable external speed control via digital input, connect one of the digits from Di2/3/4 to
COM.
to set current time. Press
to check 4 timers, make sure there is no invalid setting.
for 3 seconds to retrieve factory setting.
can stop the device. Please do not apply voltage to these inputs.
DIGITAL INPUT
ANALOG INPUT
to
or
indicates the device is waiting for start time.
for 3 seconds.
RS485
5
for 3 seconds to unlock
RELAY
OUTPUT
Fig 5