Setting & Operation; Control Panel; Mode Selection; Timer Setting - AquaForte Vario+ 1100 Bedienungsanleitung

5. SETTING & OPERATION

5.1 Control panel

Power Consumption
Speed in RPM
Day/Night/Backwash
(Low/Med/high speed)
Lock/Mode
On/Off

5.2 Mode selection

The frequency inverter has 3 modes(speed ranges).You can either run your pump at a constant
speed choosing from "M" or set up to 4 timers for daily operation, each with an individual speed.
Mode
Night (Low)
Day (Medium)
Backwash (High)
When plug in,
①
mode. Press
Up on start, pump will run at a maximum speed (2900
②
rpm) for a one-minute self-priming.
Press to choose a running speed, use
③
to adjust by 50RPM to a specific running speed if
needed.
Upon completion of self-priming, pump will automatically switch to the speed pre-set,
indicates the pump is running and showing current RPM and power consumption.

5.3 Timer setting

To run the pump at a different time or speed to take advantage of electricity tariffs during the day,
you can set up to 4 timers.
Step1: Press to
Speed range
1200~1650 rpm
1700~2400 rpm
2450~2900 rpm
lights on, the device still in OFF
to start.
enter timer setting
or
4
Current time
Timer on/Timer off
Timer
Increase/Decrease
Default speed
1400 rpm
2000 rpm
2900 rpm