Operation - OK. ODW 6011 A2 FS B Gebrauchsanweisung

Size = A5
EN

OPERATION

Washing dishes
11 • Consider following steps to start the washing process:
1. Load the dishwasher basket.
2. Add detergent or rinse aid.
Important: Make sure the water-tap/water supply is open, the appliance is connected to the
mains and the door is closed correctly.
3. Push the
4. Press P to choose your program, refer to chapter Choosing Program. If the dishwasher is
not completely loaded, then you can additionally select the half load mode. This mode
allows you to save both water and electricity when using the bottom and top basket of your
dishwasher. Press the button 1/2 and the half load indicator lights up.
Note:
• This mode can only be used with the program setting Intensive, ECO and 90 min.
• We recommend to use the half load function if the dishes are only slightly soiled.
5. For timer function (delay), please refer to chapter TIMER - DELAy WASHING. Push the
button.
• To stop the process push the
Note: The program lights show the state of the dishwasher:
a) Program light on: standby or pause.
b) Program light blinking: washing process ongoing.
6. When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds, then
stop.
- Turn off the appliance using the
- Open the door of the dishwasher.
Warning! It is dangerous to open the door when washing, because the hot water may scald
you.
- Wait a few minutes before unloading the dishwasher to avoid handling the dishes and
utensils while they are still hot and more susceptible to breakage. They will also dry better.
- Unload the dishwasher.
Change/ pause the washing cycle
• You can modify the washing program when the dishwasher just runs for a short time. Otherwise,
the detergent may have already been released, and the appliance may have already drained the
wash water.
- Press the
machine will switch to standby mode.
- Change the program to the desired cycle setting.
- Press the
Note: If you open the door during washing, the machine will pause. When you close the door, the
machine will continue working after 10 seconds.
• If you forgot a dish you can pause the process and add it, but make sure the detergent
compartment has not already opened.
1. Press
2. After the spray arms have come to rest, you can open the door completely.
3. Add forgotten dishes.
4. Close the door and press the
seconds.
IM_ODW6011 A2 FS B_190415_V04_HR.indb 22
switch to turn on the dishwasher.
button again.
button and then the Program selection button P for more than 3 seconds. The
button again to continue washing process.
button to pause the washing process.
button again and the dishwasher will continue after 10
22
button and shut off the water supply.
15/4/2019 13:44