Configuring Your Solution; Configuring Your Hardware; Configuring Your Software - Dell PowerVault NX1950 Installationsanleitung

Configuring Your Solution

This section provides information on configuring the hardware and
software for your PowerVault NX1950 storage solution.

Configuring Your Hardware

The PowerVault NX1950 storage solution is configured from Dell to
include the following peripherals that are required for the solution:
For information on setting up your hardware or racks, see the following
documents:

Configuring Your Software

Your PowerVault NX1950 storage solution is pre-configured from Dell with
the required software for the solution and includes the following software:
Downloaded from www.Manualslib.com
NOTE:
Throughout this document PowerVault NX1950 storage system refers
to the individual storage unit and PowerVault NX1950 storage solution refers
to the configuration of the storage unit along with the storage arrays.
• PowerEdge™ Expandable RAID Controller (PERC) 5/i for internal
hardware redundant array of independent disks (RAID) 1 feature
• Serial attached SCSI (SAS) 5/E host bus adapter (HBA) controller
to connect to the PowerVault storage sub-system
• Dual-port network interface card (NIC) for additional client network
connectivity (a total number of four Gigabit Ethernet data
connections are available)
• Dell Remote Access Card (DRAC) 5 for remote restore capabilities
and lights-out management
• Dell PowerVault NX1950 Systems Getting Started With Your System
• Dell PowerVault NX1950 Systems Hardware Owner's Manual
• Dell PowerVault MD3000 documentation
• Windows Unified Data Storage Server 2003, x64 operating system
• Modular Disk Storage Manager
• PowerVault MD3000 Volume Shadow-Copy Service (VSS) and Virtual
Disk Service (VDS) providers
• Dell Storage Initialization Wizard
manuals search engine
Installation Guide 7