How To Use The Remote Control - Num'axes Canicom Spray Gebrauchsanleitung

• Reset of the spray counter on the remote control
To reset the spray counter after having refilled the collar tank, proceed as follows:
− Activate the remote control.
− Select the collar for which you want to reset the counter by briefly pressing the 0 button of the
remote control (the number 1 or 2 appears on the LCD screen).
− Press and hold the 0 button (for minimum 5 consecutive seconds) until the tank symbol on
the LCD screen is full.
Diagram 8
Reset the spray
counter

How to use the remote control

●
The Canicom Spray remote control is designed to operate with 1 or 2 receiver collars.
• 0 button: dog selection / reset of the spray counter
Before sending any training instruction (beep sound, vibration or spray), you have to select the
dog you want to send a message to. In order to select the dog, briefly press the 0 button of the
remote control (the number 1 or 2 appears on the LCD screen).
The 0 button is also used to reset the spray counter (see § Reset the spray counter on the
remote control).
• button: beep sound
If you press the
beep for as long as the button is pressed.
With the beep sound you can:
− send a warning to your dog when he is disobedient,
− draw his attention...
It's very important to always use the beep sounds in the same way in order not to
disturb your dog.
• V button: vibrations
If you press the V button, the receiver collar will emit vibrations. The collar will continue to vibrate
for as long as the button is pressed but no more than 8 seconds maximum.
If you press the V button for more than 8 seconds, the collar will automatically go into safety
mode for a few seconds before restarting itself normally.
Downloaded from www.Manualslib.com
Empty tank
collar 1
button, the receiver collar will emit beep sounds. The collar will continue to
manuals search engine
Gb - 23
Full tank
collar 1