Inhaltsverzeichnis
Werbung
ENG - Before installing make sure the supporting surface will support the combined load of the equipment and
hardware. Screws must be tightly secured. Do not overtighten screws or damage can occur and product may fail.
Never exceed the Maximum Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift
and position equipment. This product is intended for indoor use only. Use of this product outdoors could lead to
product failure or personal injury. Be careful not to pinch fingers when operating the mount. For support please
call customer care at 1-800-865-2112.
ENG
Symbols
ENG
WARNING
#
ENG
Skip to step.
ENG
Do not overtighten screws.
ENG To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
3
4
x3
ENG
Screws must get at
least three full turns
and fit snug.
ENG
Display center.
+1/2
WARNING
ENG
Tools Needed for Assembly.
3/8"
(10mm)
3
2015-07-29
#:203-9504-5
7/16"
(11mm)
(2019-01-02)
Werbung
Inhaltsverzeichnis
