Operation - VONROC S_HT501DC Originalbetriebsanleitung

the battery has left.
• When the lights are not burning it means the
battery is empty and must be charged
immediately.
Charging the battery with the charger (Fig. E)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (11) as shown in Fig. E.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators (12) on
the charger (11) will lighten up and show the
charger status.
The charger has 2 LED indicators (12) which indica­
te the status of the charging process:
Red LED Status Green LED status
Off Off
Off On
On Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.

4. OPERATION

Before using, always visually inspect to
see that the blades, blade bolts and cutter
assembly are not worn or damaged.
WWW.VONROC.COM
Using your hedge trimmer
• For your own safety and for best results read
• This hedge trimmer is made for cutting hedges
Switching on and off (Fig. A)
• To switch the trimmer on, press the safety
Charger status
No power
• To switch off, release one or both switches.
Standby mode:
Trimming a hedge ­ best method
- No battery is
• Apart from hedges the hedge trimmer may also
inserted or,
- Battery inserted
• The best cutting effect is achieved when hol-
but charging has
finished
• The opposite rotating knives cut on both sides,
Battery charging in
progress
• The side of the hedge are trimmed using curved
• Ideally a hedge should be wider at the bottom
• When trimming the sides of the hedge, trim
• When trimming the top of the hedge, trim away
You may not use the hedge trimmer
without the protection guard.
Always use both hands to hold the
hedge trimmer and keep it away from
your own body.
the following user advice and do not use this
product for anything other than its intended
purpose.
and bushes. All other use that is not specifically
allowed in this manual mat lead to manage to
the hedge trimmer or injury to the user.
switch (7) and the start switch (1) at the same
time.
be used for cutting bushes.
ding the blade at an angle to the of approx. 15°.
and it is therefore possible to trim the hedge in
both directions.
shaped movements from the bottom and up-
wards.
than the top. This will improve light penetration,
keeping the hedge healthy. If possible, trim
both sides of the hedge.
from the bottom upwards. This will ensure there
are no hedge trimmings obscuring or interfering
with your cut strokes. The blade should not be
forced to cut too deep. Cut lightly through the
surface of the hedge.
from you but do not over-reach. It is much wiser
and safer to move along and cut within your
reach remaining on two feet at all times.
EN
9