Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting and service works
The device may only be installed and operated by qualified persons (in accordance with EN 62368-1) or by persons
who have been instructed by experts in accordance with the rules of technology. Maintenance work may only be car-
ried out by qualified service personnel. Before starting the service work, switch off the operating voltage and secure it
against being switched on again. In the event of service or danger, the mains plug serves as a disconnect device from
the mains voltage and must therefore be accessible and usable at all times. In order to guarantee interference immuni-
ty, all device covers must be screwed tight again after opening.
Fuses are only to be changed by authorised specialists. Only fuses of the same type may be used.
Repairs
Repairs may only be carried out by the manufacturer. Improper repairs can pose significant risks to the user. In the
event of malfunctions, the device must be disconnected from the mains and authorised specialist personnel must be
consulted. If necessary, the device must be sent to the manufacturer.
Thunderstorm
According to EN 60728 part 1 safety requirements, due to increased risk of lightning, maintenance and / or installation
work should not be carried out during thunderstorms on the device or the system.
High overvoltages (lightning strikes, overvoltages in the power grid) can damage insulation that serves to protect
against mains voltage.
Ambient temperature
The permissible ambient temperatures specified in the technical data must be observed for operation and storage,
even if the climatic conditions change due to external influences (solar radiation etc.). Overheating the device can
damage the insulation that serves to isolate the mains voltage.
Termination
Unused coaxial connections should be terminated with 75 Ohm terminating resistors. For DC-supplied connections,
DC voltage decoupling must be used or use 75 Ohm terminating resistors with integrated DC decoupling.
Attention
This module contains ESD components! (ESD = Electrostatic Sensitive Device).
An electrostatic discharge is an electrical current pulse, which can flow through an electrically insulated material, when
triggered by a large voltage difference.
To ensure the reliability of ESD components, it is necessary to consider their most important handling rules:
» Pay attention permanently to potential equalisation (equipotential bonding)!
» Use wrist straps and approved footwear for personnel grounding!
» Avoid electrostatically chargeable materials such as normal PE, PVC, polystyrene!
» Avoid electrostatic fields >100 V/cm!
» Use only labeled and defined packing and transportation materials!
Damage caused by faulty connections and/or improper handling are excluded from any liability.
Recycling
All of our packaging materials (packaging, identification sheets, plastic foil and bags) are fully recyclable. The devices
are to be disposed of properly according to the current disposal regulations of your district/country/state as electronic
scrap.
§
Guarantee conditions
The general terms and conditions of Polytron-Vertrieb GmbH apply. The general terms and conditions can be found on
our website at: https://polytron.de/index.php/en/company/general-terms-and-conditions.
Precautions to ensure the electromagnetic compatibility (EMC)
All covers and screws must be fixed and tightened; contact springs must not be oxidized or bent.
Hereby, Polytron-Vertrieb GmbH declares that the devices FSA 16 A and FSA 2-8 A complies with the Directive
2014/53/EU. The CE declaration is available at:
GENERAL INFORMATION ON THE OPERATING INSTRUCTIONS
All parameter data are examples only.
User adjustable parameters are freely selectable.
Menu views can vary slightly depending on the software version; the operability does not change as a result.
The images in this manual are for illustrative purposes only.
WEEE-Reg.-Nr. DE 51035844
https://polytron.de/index.php/en/services/declarations.
5
Werbung
