Schwamborn BEF 204 Originalbetriebsanleitung Seite 15

EN Floor milling machine BEF 204
3 Operation
The power socket serving as the electric supply
should be supported and installed according to
local regulations.
All installed plugs and couplings have to be
protected from splash water!
Only suitably knowledgeable, qualified profes­
sional electricians may perform work on any
electrical parts of the system.
Risk of poisoning due to harmful substances at
the workplace!
Eating, drinking or smoking at the workplace is
prohibited! Always eat in break rooms or
canteen areas!
After completing the work, thoroughly clean
yourself!
A general inspection of the machine must be
conducted before starting up the machine. Parti­
cular attention should be paid to damaged or
loose components, and wear.
The machine may only be put into operation in
perfect technical condition.
Do not operate the machine in areas where
there is risk of explosion or near flammable ma­
terials!
Adding to or modifying the machine in any way
that could compromise operating safety is prohi­
bited!
3 Operation
Observe the safety instructions in Chapter 2.
Risk of injury from parts flung out during milling!
Wear protective clothing and protective goggles!
Wear safety shoes!
Wear safety gloves!
Proceed with the greatest care and caution!
Danger of injury from loud noise during milling
operation of the machine!
Always wear hearing protection when the ma­
chine is in operation!
Risk of injury from parts flung out! The surface
to be milled has to be free from obstacles,
soiling and loose objects that can be flung out
during milling.
Risk of injury from rotating machine parts! Limbs
and clothing can be drawn in!
Proceed with the greatest care and caution!
High‐voltage electrical current can be fatal! Do
not allow the power line to be run over, crushed
or pulled on!
The operating range is limited by the length of
the power line. Stop the machine in time!
15