The Trekstor Ndas Device Management; Datastation; Registering And Mounting A New Trekstor; Using The Assistant (Wizard) - trekstop DataStation maxi z.ul Handbuch

3) The TrekStor NDAS Device Management

3.1) Registering and mounting a new TrekStor

maxi z.ul
Procedure using Windows® 2000 / XP / Vista
• After restarting your operating system, another symbol appears in the
Info area of the task bar with a balloon tip. To set up a
maxi z.ul
• Alternatively, you can right-click on the symbol
menu item "r
registration wizard then starts.
Note: If the TrekStor NDAS Device Management is not activated, start it under "s
 p
rogrAms
• Follow the installation software instructions for setting up the
DataStation maxi z.ul
• You will be asked to assign a name for the new drive
DataStation maxi z.ul
(the
EN
• You must enter the identification number (ID) in the next window.
Note: The identification number (ID) and the write key (KEY) can be found
on your
quick guide.
• If you would like to gain write access to the
maxi z.ul
• After you have successfully registered the
z.ul
, you can then mount it – i.e., integrate it into your operating system.

using the assistant (Wizard)

using the assistant, click on this balloon tip or on the symbol
egistering A new deviCe
"  "t s nDAs s
rek tor
DataStation maxi z.ul
, you must also enter the write key (KEY).
... " from the menu that appears. The
"  "t s
oftwAre rek tor
.
).
or on the reverse side of the

DataStation

DataStation maxi
– 36 –
DataStation
DataStation
and select the
nDAs D m
eviCe AnAgement
.
"
tArt
".