Oil Level Check And Changing The Oil; Oil Alert System - Westfalia 80 31 79 Bedienungsanleitung

Oil Level Check and Changing the Oil

Only check the oil level by switched off engine and make
sure the snow thrower is standing horizontally.
1. Turn the dipstick (20) counter clockwise and remove
it. Clean the dipstick and insert into the oil filler neck
(do not screw in).
2. Remove the dipstick again and check the oil level. If
the oil level is up to
H, the amount of oil is enough
L, the amount of oil is too less.
3. For changing the oil first unscrew the oil drain plug (19) by using the
wrench of the size 10 and turn it counter clockwise. Remove the dipstick
from the oil filler neck.
Wait until the engine oil has drained out into a suitable tub. Preferably
change the oil when the engine is still warm (not hot), as warm engine oil
can drain quickly and completely from the machine. Attention! Dispose off
used engine oil environmentally friendly.
4. Re-tighten the oil drain plug and fill engine oil again into the machine. Do
not fill more than up to the H marking. Tighten the oil tank with the dipstick.
Hint: The engine is equipped with two
oil filler necks (B). For changing oil, first
unscrew the oil drain plug (19) and
afterwards remove both dipsticks from
the oil filler necks. By doing this, oil
bleeding can
because the oil will drain more quickly.

Oil Alert System

The Oil Alert System will stop the engine before the oil level falls below the
safe limit. In this case it will not be possible to start the engine, or it will cut-out
automatically after a short period of time. Starting the engine again will only be
possible after re-filling the oil tank.
Maintenance
be performed easily
36
H (high)
L (low)
19
B