Filling The Snow Thrower With Engine Oil; Filling The Tank With Fuel - Westfalia 80 31 79 Bedienungsanleitung

6. Place the discharge chute (12) on the snow
thrower and secure it with the plastic holders
(I), the screws (II), the washers (IV) and the
M6 nuts (III). Make sure the washers and nuts
are facing up in order to be able to tighten the
nuts easily.
7. The crank arrangement (3) consists of the
upper part with hand crank and the lower part
with spiral drive. Slide the upper part of the crank
arrangement through the eyelet (see picture on page
24).
8. Insert the
ment through the mounting support on the housing,
secure it with the washer (VI) and fix the crank
arrangement (3) with the cotter pin (XII).
9. Secure the upper and the lower part of the crank
arrangement together by using the screw (X), both
washers (V) and the nut (IX).
The snow thrower is completely assembled.
Before each use, check all parts for proper fit and
tighten alls screws and nuts.

Filling the Snow Thrower with Engine Oil

1. Fill approx. 0.5 l SAE 10W30 engine oil into the oil filler neck (20).
Preferably use the included funnel and tube for
filling.
2. Make sure the oil filler neck is securely tightened
with the screw cap, which also serves as dipstick.

Filling the Tank with Fuel

Only fill unleaded regular or premium petrol in the tank. Unleaded petrol
produces fewer engine and spark plug deposits and extends the service life of
the exhaust system.
1. Open the tank cap (14) by turning counter clockwise. Remove the cap.
Carefully fill unleaded petrol into the tank from a suitable container. Make
sure not to overfill the tank.
Assembly and Operation
lower part of the crank arrange-
32