EN
PLEASE NOTE
Make adjustments in 1/4 turn. Do not
exceed one full turn of the Adjusting Screws. Over
tightening the belt can significantly shorten the belt life.
How To Tension The Running Belt
When walking on the running platform, if a slipping sensation is experienced the belt has
stretched and is slipping across the rollers.
The running belt will stretch over time. This is a normal and common adjustment to make on any treadmill. To eliminate any slipping
please follow the instructions below—
IF IT IS A MINOR ADJUSTMENT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1
Tension both bolts on the rear roller 1/4 turn clockwise.
2
Try the treadmill at 1.0 km/h (0.5 mph) speed to check for slipping.
3
Try the treadmill again to check for slipping.
IF IT IS A SIGNIFICANT ADJUSTMENT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1
Place 4 pieces of tape, 1,000mm apart, on both edges of the running belt.
2
Tighten the tensioning bolts until the distance between the tapes are increased to 1,005mm (39.75 inches).
3
Try the treadmill again to check for slipping.
1,000mm
1,000mm
1,005mm
1,005mm
Intenza Treadmills Handbook. Maintenance. How To Tension The Belt
25