Residual Risks - Ryobi RPD680K Übersetzung Der Originalanleitung

Safety, performance, and dependability have been given
top priority in the design of your percussion drill.
INTENDED USE
The percussion drill / driver is intended to be used only
by adults who have read and understood the instructions
and warnings in this manual, and can be considered
responsible for their actions.
The product is intended for drilling into various materials,
including wood, metal, and plastics using a drill bit having
suitable screwdriver bit, it can be used for inserting and
removing screws. It can also be used in impact drilling
mode for drilling masonry and similar materials.
Do not use the product for any other purpose. Use of the
product for operations different from intended could result
in a hazardous situation.
WARNING
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result in
Save all warnings and instructions for future reference.
DRILL AND SCREWDRIVER SAFETY WARNINGS
SAFETY INSTRUCTIONS FOR ALL OPERATIONS
Wear ear protectors when impact drilling. Exposure
to noise can cause hearing loss.
Use the auxiliary handle(s). Loss of control can cause
Brace the tool properly before use. This tool
produces a high output torque and without properly
bracing the tool during operation, loss of control may
Hold the power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory or fastener may contact hidden wiring.
Cutting accessory or fastener contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
SAFETY INSTRUCTIONS WHEN USING LONG DRILL
BITS
Never operate at higher speed than the maximum
speed rating of the drill bit. At higher speeds, the
bit is likely to bend if allowed to rotate freely without
Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher speeds,
the bit is likely to bend if allowed to rotate freely without
Apply pressure only in direct line with the bit and do
not apply excessive pressure. Bits can bend causing
ADDITIONAL SAFETY WARNINGS
Wear safety goggles to protect your eyes from flying
particles and splinters.
When working on walls, ceilings, or floors, avoid hitting
electrical wiring and gas or water pipes.
The product will restart automatically if stalled. Switch
off the product immediately if it stalls. Do not switch on
the product again while it is still stalled, as doing so
could trigger a sudden recoil with a high reactive force.
Determine why the product stalled and rectify this,
paying heed to the safety instructions.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise and the operator
should pay special attention to avoid the following:
Risk of electrocution if electric cables are drilled into
– Always grasp the tool by designated handles, do
not touch the drill bits.
Damage to the respiratory system
– Wear respiratory protection masks containing filters
appropriate to the materials being worked. Ensure
adequate workplace ventilation. Do not eat, drink or
smoke in the work area.
Damage to hearing
– Always wear effective hearing protection and limit
exposure to noise.
Damage to eyes from flying dust and debris particles
– Always wear suitable eye protection.
– Hold the tool by designated handles and limit
exposure to vibration. See "RISK REDUCTION".
– Dust created by operating the product can cause
mask with filters suitable for protecting against
particles from the material being worked on.
RISK REDUCTION
It has been reported that vibrations from handheld tools
may contribute to a condition called Raynaud's Syndrome
in certain individuals. Symptoms may include tingling,
upon exposure to cold. Hereditary factors, exposure to
EN
English
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
1