English - Philips XD3110/09 Bedienungsanleitung

English

8
- Follow your country's rules for the separate collection of electrical and electronic products. Correct
disposal helps prevent negative consequences for the environment and human health.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The suction power is
insufficient.
When I use my vacuum
cleaner I sometimes feel
electric shocks.
Possible cause
The dustbag is full.
The filters are dirty.
The suction power is set to a
low setting.
The nozzle, tube or hose is
blocked up.
Your vacuum cleaner builds
up static electricity. The lower
the air humidity, the more
static electricity the
appliance builds up.
Solution
Empty the reusable dustbag or replace
the disposable dustbag.
Clean or replace the filters.
Increase the suction power with the
regulator on the appliance or on the
handgrip.
To remove the obstruction, disconnect
the blocked-up item and connect it (as
far as possible) the other way around.
Switch on the vacuum cleaner to force
the air through the blocked-up item in
opposite direction.
Discharge the appliance by frequently
holding the tube against other metal
objects in the room (for example the
legs of a table or chair, a radiator etc.).
You can also raise the air humidity level
in the room.