Instructions Foruse Of The Equipment; Maintenance; Holding The Hedge Trimmer When In Use - Okay FHS 1555 Ultralight Gebrauchsanweisung

A
• Now insert the loop of cable from below into the mains
lead cleat. Once you have released the cable hook
button, it will automatically return to starting position
B and the cable will be held in place.
B
• Press the cable holder button again to loosen the
cable and pull out the cable.
Extension flexes with a length of more than 30m reduce
the machine's output.
Instructions for use of the equipment
Do not use the trimmer in rain or for cutting wet
hedges!
Check the hedge trimmer flex and its connections
before each and every use for visible signs of
damage (disconnect the power plug)! Do not use
a faulty flex.
Gloves:
Protective gloves must be worn when using the
hedge trimmer.
Switching the hedge shears on/off
When switching the hedge shears on take a safe stand.
These hedge shears have a two-hand safety switch. To
switch the hedge shears on the bar switch in the handle
(A) and the grip switch of the bow-type handle (B) must
be pushed down. To switch the device off let go of both
switches. The motor already stops if one of the two
switches is released.
GB | Operating Instruction
X
A

Maintenance

Always disconnect the plug from the power socket
before commencing any work on the machine.
Important: Always clean and oil the blades after pro-
longed use of the hedge trimmer. This will greatly affect
the life of the equipment. Damaged cutting units must
be properly repaired immediately. Clean the shearing
blades with a dry cloth or – in case of heavier dirt – with a
brush. Attention: Danger of injury!Oiling of the blades
should ideally be carried out using an environmentally
friendly lubricant.
Sharpening of the blades
The blades generally do not need servicing and do not
require resharpening if used correctly.
Changing the blades
Only correct installation of the blades will guarantee
problem-free operation and function of the above men-
tioned safety feature of the blades. Changing of the
blades should therefore only be carried out at a special-
ist workshop.

Holding the hedge trimmer when in use

This equipment will enable you to cut or trim bushes and
hedges easily and comfortably.
6
B