Herunterladen Inhalt Inhalt Diese Seite drucken

Accessories - Agatec LT 200 Bedienungsanleitung

Automatischer laser
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 30
LT200-5langues
12/01/08

5. Accessories

Detector for grade rods or
handheld applications
Level vial
LCD
screen
(front)
Detection
window
Rod clamp
Turn to attach
clamp to detector
Turn to tighten
or remove clamp
from rod
12
Downloaded from
www.Manualslib.com
18:55
Page 12
On-grade
alignment notch
Keypad
Choice of
sound level
Choice of
accuracy
On/Off
LCD screen
Bubble vial
to plumb
9V battery
compartment
(follow polarity
indications
inside)
manuals search engine
High
Near
grade high
On-grade
Near
grade low
Low
1. Press the On/Off key to turn on the detector.
2. Press the middle key to select the accuracy (deadband).
3. Press the top key to select the sound level.
4. Turn the detection window towards the laser beam, and
move the detector up or down according to the information
(rear)
given on the LCD display. There are 5 channels of information,
or grade indicators.
A down arrow indicates you must move the detector down to
reach the laser reference; an up arrow, move it up. When a
horizontal line appears on the display, the detector is at the
rod
same level as the laser beam.
5. Press the On/Off key to turn the detector off. It will
automatically shut off after ten minutes if not used (and give a
warning beep).
6. Keep the detection window clean, using a soft cloth and
glass cleaner.
• LCD Display
Low battery
Blinking: Normal volume
Solid: Loud
No horn: Mute
Standard
Fine
(
Default
)
mode
• Using the detector
Battery status
Sound
Accuracy
13

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis