Laser 6325 Handbuch Seite 8

Applications
The application list for this product has been compiled cross referencing the OEM Tool
Code with the Component Code.
In most cases the tools are specific to this type of engine and are necessary for Cam belt or
chain maintenance.
If the engine has been identified as an interference engine valve to piston damage will
occur if the engine is run with a broken Cam belt.
A compression check of all cylinders should be performed before removing the cylinder
head.
Always consult a suitable work shop manual before attempting to change the Cam belt or
Chain.
The use of these engine timing tools is purely down to the user's discretion and Tool
Connection cannot be held responsible for any damage caused what so ever.
ALWAYS USE A REPUTABLE WORKSHOP MANUAL
Model Model
Vauxhall/Opel Signum Turbo | Vectra-C Turbo Z20NET | B207E | B207L | B207R 2002-2008
Saab
9-3 1.8 Turbo
9-3 1.8 Turbo BioPower
9-3 2.0 Turbo
9-3 2.0 Turbo BioPower
9-3XT
www.lasertools.co.uk
4
Engine Code Year
2002-2011
2002-2011
Z20NET | B207E | B207L | B207R
2002-2012
2010-2012
2009-2011
Instructions
Preparation
• Preparation will vary greatly dependent on the make and model.
Tool Connection recommend manufacturer data be consulted that is relevant to the
model being worked on.
• Set engine to TDC number 1.
Component Descriptions:
Component A: Crank Holding Tool - Used
to hold the crankshaft pulley while
loosening and tightening the crankshaft
pulley fixing bolt.
N.B. the manufacturer recommends
the replacement of the fixing bolt,
see manufactures instructions.
Components B: Inlet Camshaft Alignment
Block & C Exhaust Camshaft Alignment
Block -Used to lock the camshafts in their
timed position.
Remove the camshaft bearing caps
above number 1 cylinder and fit compo
net B onto the inlet camshaft and C on
to the exhaust cam. The arrows should
be pointing toward the chain drive and
camshaft sprocket timing marks should
be aligned. Ensure B and C sit flat on the
surface of the cylinder head.
N.B: If camshaft sprockets require
loosening the bolts should be replaced
(see manufacturer data) Refer to Fig. 1
Component D: 1.0mm Tensioning Pin -
is used to lock the balance shaft drive
chain tensioner in it retracted position.
Push the tensioner plunger fully home
and insert the pin as shown in Fig. 2.
www.lasertools.co.uk
B & C
Fig. 1
Fig. 2
D
5