Mini Compressor; Technical Data - Eufab 21068 Bedienungsanleitung

MINI COMPRESSOR

1. TECHNICAL DATA

• Operational voltage: 12 Volt
• Maximum pressure: 17 bar / 250 PSI
• Power supply: 12 Volt
• Size (L x W x H): Approximately 15 x 6.5 x 13 cm
• Weight: Approximately 620 g
• Accessories: 3 adapters
2. OPERATING INSTRUCTIONS
Universal use, for example, for pumping up car,
motorcycle and bicycle tyres with car valve, sports balls,
inflatable toys.
1. Do not increase the air pressure above the manufac-
turer recommendation!
2. Protect the compressor and its components from
damp!
3. Do not leave the operating compressor unattended!
4. Keep children away and do not permit children to use
this device!
5. Only use this product for the intended use!
6. Do not manipulate or disassemble the compressor!
7. If the compressor makes unusual noises or overheats,
switch off immediately and allow at least 30 minutes
to cool down. When operating for a longer period of
time, switch off after 10 minutes, leave to cool for 30
minutes!
8. Check the compressor before use. Any damaged, cra-
cked or broken components should be maintained by
qualified technicians only!
4
1. Manometer
2. Handle
3. Air slot
4. Cable holder
(for winding)
5. 12 Volt adapter
9. Never expose the compressor to frost, rain or tempe-
ratures over 30° C or under – 30° C!
10. Never use on people or animals!
11. Make sure that the hose and cable are not exposed to
sharp edges, oil or objects that are too hot!
12. Warning! For your own safety, only use accessories
or replacement parts specified in the instructions or
that the manufacturer has recommended!
WARNING
These instructions are designed to
give information about the functions
and performance.
Keep these instructions as reference
material for future use. Before using
the device for the first time, check
the contents of the box for integrity
and completeness!
Pumping up car or bicycle tyres
1. Undo the 12 Volt cable.
2. Fit the car valve adapter to the valve.
3. Start the compressor by connecting the 12 Volt adap-
ter with the 12 Volt connection of your vehicle. Wait
until the required tyre pressure has been achieved.
4. Separate the 12 Volt connection from the vehicle and
remove the car valve adapter from the tyre valve.
NOTE
Check the tyre pressure of your vehicle
using the recommended values in the
operating instructions to avoid over
pressure. Bicycle tyres should be checked
using the tyre designation.
Pumping up sports equipment (e.g. basket balls)
or balloons
1. Undo the 12 Volt cable.
2. Screw the ball/balloon adapter to the threaded
connector at the hose end.
3. Insert the ball/balloon adapter into the valve of the
object you wish to pump up.
4. Start the compressor by connecting the 12 Volt adap-
ter with the 12 Volt connection of your vehicle. Wait
until the desired firmness has been achieved or the
object is completely pumped up.
5. Remove the adapter from the valve of the pumped
up object and unscrew to the remove the threaded
connector at the hose end.
6. To switch off the compressor, separate the link with
the 12 Volt connection.
!