True Systems P-SOLO Ribbon Bedienungsanleitung Seite 27

overloading the preamp.
• SIG indicates that a signal is present
on the channel. It illuminates when
the signal level exceeds -2dBu.
• + illuminates when the signal
reaches operating level of + dBu.
• OL illuminates when the signal level
exceeds +26 dBu, which is  dB
below the overload point for the P-
SOLO
• Note that the overload level of the
P-SOLO
output*. This level exceeds the input
capability of some devices (check
manufacturer's specifications). In
such cases it is appropriate to use
the intermediate level indicators
(+, +12) to set the maximum out-
put level of the P-SOLO
match the maximum input capability
of the connected device. In other
words, it is possible to cause overload
distortion in the connected device
even though the P-SOLO
level indicator does not show a red
light.
* Maximum output level in the INP AT-
TEN mode is +27dBu.
The HIGH GAIN
selector sets the gain to a 6dB higher
range to accommodate quiet signals
and/or lower output ribbon micro-
phones. When the indicator is illumi-
nated, the gain range is 21.dB to 76dB.
In the INP ATTEN mode, the P-SOLO
is set to a fixed gain of 12dB.
The INP ATTEN mode affects both mic
and instrument inputs.
Downloaded from www.Manualslib.com
.
.is +1dBu at the
SOLO
manuals search engine
CONTROLS Front Side
27
GAIN Control
is used to set the appropriate gain
range. Normal microphone gain range
is 1. dB to 70 dB. For very hot signal
sources, the GAIN Control can be set to
the INP ATTEN mode. The GAIN Con-
trol will "click" into this position as the
knob is turned fully counterclockwise.
In the INP ATTEN mode, the P-SOLO
is set to a fixed gain of about
6dB. The INP ATTEN mode affects both
mic and instrument inputs.
The INSTRUMENT Input (DI)
is used for connection of electric in-
strument pickup or synthesizers. The
to DI we've designed for the P-SOLO
matches (or exceeds) the sonic
performance of acclaimed, dedicated
DI products. It provides excellent articu-
lation and control for electric/acoustic
bass, detail and smoothness for stringed
instruments and keyboards. A micro-
phone plugged into MIC IN will be au-
tomatically de-selected when an instru-
ment is connected to the INSTRUMENT
input. Settings for GAIN and HPF apply
to the DI input in the same manner
as they apply to mic input. The gain
range for the direct inputs is from - dB
to +0 dB at normal gain and -1 dB
in the INP ATTEN mode.
NOTE: The INSTRUMENT input is for
unbalanced sources only. DO NOT use
a TRS (balanced) plug for this input, as
the DI will not function correctly.
TRUE systems
E