Mic Input - True Systems P-Solo Ribbon Bedienungsanleitung

CONNECTORS Rear Side
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OVRIR
TRUE Systems
P - SOLO Ribbon
RoHS
2002/95/EC
e
1
SUNRISE ENGINEERING AND DESIGN INC.
TUCSON, ARIZONA U.S.A.
TRUE systems
Downloaded from www.Manualslib.com
BALANCED
9W
115 V
115/230 V
For continued protection
against re, replace only
with same type fuse:
115 T 125 mA L, 250V
230 T 63 mA L, 250V
Consult Operation Manual
for voltage selection
procedure.
manuals search engine
2
Balanced (XLR)

MIC Input

MIC
IN
Balanced (XLR)
LINE Output
OUT
Balanced (TRS)
LINE Output
Voltage Setup (inside)
50-60 Hz
Fuse Drawer
Main Power Switch
Mains Power Connector
Microphone Connection: Microphone
connection is made to an XLR MIC IN
receptacle on the rear panel. The wiring
configuration used for the microphone
connectors on the
P-SOLO
• Pin 2 is positive (+)
• Pin  is negative (-)
• Pin 1 is screen (GND)
Do not attempt to connect unbalanced
microphones to the P-SOLO
It is not intended to operate with this
type of microphone.
SOLO
is:
.