Up-And-Running In A Hurry; A Word About Cables - True Systems P-Solo Ribbon Bedienungsanleitung

UP-AND-RUNNING IN A HURRY

1. Read the "SAFETY and OPERATING
PRECAUTIONS" on page 2 of this
manual.
2. Check the voltage selector on the
rear panel to make sure it is set for
the appropriate AC mains voltage in
your area.
. After making sure the main power
switch is off, connect the AC power
cord.
. Connect output signal cables between
P-SOLO
and the analog line level input of
your recorder, mixer, signal processor,
etc. Use either the 1/" TRS or XLR
balanced output connectors. See the
section "Connections" for wiring de-
tails.
. Connect a mic cable (and mic) to
MIC IN connector on the rear panel.
6. Turn on the AC power.
7. Adjust GAIN control for adequate
signal level as indicated on the P-
SOLO
the level indicators of the device to
which it is connected.
8. If necessary, select HIGH GAIN mode
for an additional 6dB of gain.
If you're using the DI for electric in-
strument input:
1. Connect your instrument cables to
the INSTRUMENT (DI) connector on
the front panel. Any microphones
plugged into MIC IN will be auto-
matically de-selected NOTE: DO
NOT use TRS plugs for these inputs,
as the DI will not function correctly.
Downloaded from www.Manualslib.com
BALANCED OUT
level indicators or on
SOLO
manuals search engine
UP-AND-RUNNING
2
2. Adjust GAIN control for adequate
signal level as indicated on the P-SOLO
level indicators or on the level
indicators of the device to which it is
connected.

A Word about Cables ...

Most users of the P-SOLO
invested much time and money in their
selection of microphones and pream-
plifiers. We recommend that you give
some consideration to the microphone,
instrument and output cables you select,
as well.
• Use high quality, low capacitance
cable. Braided shielding and "star
quad" type mic cables will perform
better in electrically noisy environ-
ments. Manufacturers such as
Canare, Mogami (and others) make
high performance cable of this type.
• Some "house brand" cables are
made by quality manufacturers, but
others can be inferior. Be careful.
Use cables with highquality connec-
tors (Neutrik, Switchcraft, etc.).
• Our studio testing has shown that
some of the more esoteric guitar/in-
strument "super-cables" do, indeed,
sound better. Noticeable improve-
ment, but at a stiff price. Try before
you buy!
• Avoid excessive cable length.
• Replace damaged connectors and
cables.
have
TRUE systems
E