Iso-Tech ILCM 06 Bedienungsanleitung Seite 6

plays the battery capacity when
e replace the battery when 0%
Downloaded from www.Manualslib.com
auto Power Off (aPO) enable / Disable
aUtOHOLD enable / Disable
In AUTOHOLD mode, if the measured value remains
within ±10 counts over 10 measuring cycles the
instrument will beep 4 times, the measured value
will be held on the display and "AUTOHOLD" will
be displayed.
Subsequently if the measured value changes by ±10
counts, the instrument will beep, "AUTOHOLD" will
disappear and the instrument will revert to displaying
the new readings until the next AUTOHOLD conditions
are met.
Note: When AUTOHOLD activates, the displayed
reading will be held for 3 seconds if the clamp jaws are
removed from the cable. During this time the HOLD
key can be pressed to hold the reading indefinitely.
manuals search engine
ILCM 06 English
Press < 3sec
at power on
Press > 3sec
at power on
Press < 5sec
at power on
Press > 5sec
at power on
5