Troubleshooting; Safety Regulations - Gastros InductWarm 130 Betriebs- Und Montageanleitung

Troubleshooting

Possible Problems
Fault
LED is not flashing
LED flashing
Infra red remote control is not
working
Dish is not warm enough

Safety Regulations

Responsibility
The InductWarm
operation is assured. The InductWarm
sical or mental limitations, unless they are instructed and monitored while using the appliance by a person respon-
sible for their safety.
20
Downloaded from www.Manualslib.com
Cause
No power supply
Power line fuse tripped
Appliance not switched on
Appliance defect
Pan is not detected
Battery is empty
Sender or receiver are solid
No elecrticity between battery and
remote control
Incorrect placement of dish
Too little energy input
Dish is not induction compatible
130 reflects the state of the art and has been built in accordance with the valid CE guidelines. Safe
®
130 appliance is not intended to be operated by children or persons with phy-
®
manuals search engine
Remedy
Plug the appliance in,
check the plug connection
Check and reset the fuse
Check the plug connection, turn on
the power switch on the bottom of
the device
Contact customer service
Pan too small or not
induction compatible
Replace the battery
Clean sender or receiver
Ensure contact between battery and
remote control
Ensure right position above the
induction coil
Increase power level
Check induction compatibility of
dish