Seite 1
InductWarm ® Built-in and Undercounter Betriebs- und Montageanleitung: Einbaulösung Operating and Assembly Instruction: Built-in Solution Version 09/2016 - de/eng Downloaded from www.Manualslib.com manuals search engine...
Einleitung Das InductWarm 130 ist für das Warmhalten von Speisen konstruiert worden und eignet sich vor allem für den Ein- ® satz in der gehobenen Hotellerie und Gastronomie. Neben der hohen Qualität legen wir bei der Entwicklung unserer Geräte viel Wert auf ein modernes Design und eine einfache Handhabung. Das InductWarm 130 ist ein Einbausystem und kann direkt unter Stein, Glas oder Holz (10-13 mm Abstand zum Ge- ®...
Inbetriebnahme und Bedienung Entfernen Sie sämtliche Verpackungsteile und überprüfen Sie InductWarm 130 auf äussere Beschädigungen. Neh- ® men Sie das Gerät nicht in Betrieb, falls es Beschädigungen aufweist. Bitte bewahren Sie die Originalverpackung für den späteren Transport von InductWarm 130 auf. Der Luftzufuhrbereich auf der Gerätevorderseite darf nicht ver- ®...
Seite 6
Bedienung von der Buffet-Front. Um das Kabel einzustecken, entfernen Sie vorsichtig mit einem Seitenschneider ® die perforierte Abdeckung am InductWarm 130, wie in der nächsten Zeichnung abgebildet. • Um einen problemlosen Betrieb zu gewährleisten, sind ausschliesslich die getesteten Kabel der Gastros Switzerland AG zu verwenden. Infrarot Empfänger LED 1-4 Leistungstaster...
Sicherheit verantwortliche Person genau instruiert und beim Gebrauch des Geräts überwacht werden. Gastros Switzerland AG lehnt jegliche Haftung aufgrund von eigenmächtige Umbauten oder Modifikationen ab. Wenn die Netzanschlussleitung des Geräts beschädigt wird, muss sie durch den Hersteller ersetzt werden, um Gefährdun- gen zu vermeiden.
Seite 8
Bei Transport, Aufstellung, Wartung und Reparatur vom InductWarm 130 sind folgende Vorschriften und Richtlinien ® Ihres Landes in ihrer aktuellsten Version zu beachten: • Vorschriften der Elektroverbände, z.B. VDE, SEV usw. • EG – Richtlinien (in Ländern der EU) • Unfallverhütungs-Vorschriften •...
Die Werksgarantie umfasst Konstruktions-, Produktions- und Materialfehler. Weitergehende Ansprüche sind aus- geschlossen. Alle Angaben und Hinweise in dieser Anleitung wurden unter Berücksichtigung der geltenden Normen und Vorschriften zusammengestellt. Die Gastros Switzerland AG übernimmt keine Haftung für Schäden aufgrund: • Nichtbeachtung der Anleitung •...
Seite 10
Reparaturen Reparaturen dürfen nur von autorisiertem Servicepersonal ausgeführt werden. Wenden Sie sich an Ihren Fachhänd- ler, einen ausgebildeten Gastros Service-Partner oder nehmen Sie mit unserem Kundendienst Kontakt auf: servicepoint@gastros.swiss Warmhalten mit Induktion Die unter der Glaskeramik liegende Induktionsspule (1) generiert ein wechselndes elektromagnetisches Feld (2), das durch den Wirbelstromeffekt direkt im Gefässboden eines induktionsfähigen Aufsatzes Wärme (3) erzeugt.
• Es wird empfohlen die Ausdehnung des Trägermaterials mit einer umgehenden Silikonfuge zu kompensieren. Beachten Sie dazu die Einbauempfehlungen unten. • Gastros gibt gerne Empfehlungen bei der Wahl des Trägermaterials ab, übernimmt jedoch keine Haftung bei Schäden am Trägermaterial. Downloaded from www.Manualslib.com...
Holz • VORSICHT: Die Verwendung von Holz als Trägermaterial ist kritisch. • Es darf kein verleimtes oder lackiertes, sondern nur geöltes Naturholz verwendet werden. • Feuchtigkeit und/oder Trockenheit können zu Rissbildungen im Holz führen. Übersichtszeichungen Downloaded from www.Manualslib.com manuals search engine...
Beschrieb Projekt/Gruppen-Nr./Gehört zu Erstellt von Datum Entwicklung 21.07.2016 Externe Bedieneinheit Bestückungsmöglichkeiten Pfad Titel Einbaumöglichkeit Zeichnungs-Nr. Exxxxx Iw130 Blatttitel ZEICHENBLAT Alle Rechte vorbehalten C:\Users\Gastros\Desktop\Nützliche Dokumente 59 mm 25 mm 120 mm 140 mm Seitenansichten Ext.Bedieneinheit Downloaded from www.Manualslib.com manuals search engine...
Gastros erklärt hiermit, dass die oben erwähnten Produkte den unten gekennzeichneten Richtlinien – einschliesslich deren zum Zeitpunkt der Erklärung geltenden Änderungen – entspricht: Gastros herewith declares that the products mentioned above is in conformity with the applicable requirements of the following documents: EN 55011:2009 + A1:2010 EN 55014-2:1997 + Corr.1997 + A1:2001 + A2:2008...
InductWarm ® Built-in and Undercounter Operating and Assembly Instruction: Built-in Solution English version Version 09/2016 - de/eng Downloaded from www.Manualslib.com manuals search engine...
Introduction The InductWarm 130 was developed to keep food warm and to meet all specific needs of hotels and hospitality. Be- ® sides the high quality, we also focus on premium design and easy handling. The InductWarm 130 is a built-in system and can be mounted directly under stone, glass or wood (with a 10-13 mm ®...
Seite 17
Optional Accessories InductWarm ® 130 Built-in and Undercounter Connecting cable external control unit, 1000 mm 6 13 510 00 Connecting cable external control unit, 2000 mm 6 13 515 00 Connecting cable external control unit, 3000 mm 6 13 530 00 InductWarm mounting set 6 13 600 00...
130 can be controlled by an optional, external control unit. This allows a use from the buffet side. For inserting the cabel, please carefully remove the perforated cover with a side cutter, as shown in the next picture. • To ensure proper functionality only use cables of Gastros Switzerland AG Downloaded from www.Manualslib.com...
Seite 19
Infra Red Receiver LED 1-4 Power Button Operation The four power levels of the InductWarm 130 cover different warming levels. The temperature levels are indications ® only. The actual temperature depends on: material of the dish, surrounding temperature, size of the dish and the positioning above the coil.
Troubleshooting Possible Problems Fault Cause Remedy Plug the appliance in, No power supply check the plug connection Power line fuse tripped Check and reset the fuse LED is not flashing Check the plug connection, turn on Appliance not switched on the power switch on the bottom of the device Appliance defect...
Seite 21
Gastros Switzerland AG disclaims all liability in cases due to unauthorised conversions or modifications by the custo- mer. If the mains supply cable for the appliance is damaged, it must be replaced by the manufacturer, an authori- sed service agent or other similarly qualified person in order to prevent hazards. The connection for the mains plug should always be positioned so that it is freely accessible.
• Risk of destruction When the induction surface is not only being used for warming, it is necessary to ensure that the devices are turned off. Otherwise damage or burnings may occur. • Electrical shock Do not expose this system to liquids or metal objects which may cause an electric shock. •...
Seite 23
Repairs Repairs may only be carried out by authorised service personnel. Contact your dealer, a trained Gastros Switzerland AG Service Partner or our customer service department. You can contact our customer service department: servicepoint@gastros.swiss. Warming with Induction The induction coil beneath the glass ceramic dish generates an alternating electromagnetic field that produces heat in the base of an induction dish item through the principle of eddy currents.
• It is recommended to use an immediate silicone joint for the possible extension of the surface. Kindly see installation recommendations below. • Gastros can give advice in the choice of the carrier material, but assumes no liability for any damage to the surface Downloaded from www.Manualslib.com...
Wood • ATTENTION: The use of wood as a support material is critical. • Do not use glued or lacquered wood, only oiled natural wood. • Moisture and / or drought can lead to cracks in the wood. Assembly Drawing Downloaded from www.Manualslib.com manuals search engine...
Projekt/Gruppen-Nr./Gehört zu Erstellt von Datum Entwicklung 21.07.2016 External Control Unit Equipment Options Pfad Titel Einbaumöglichkeit Zeichnungs-Nr. Exxxxx Iw130 Blatttitel ZEICHENBLA Alle Rechte vorbehalten C:\Users\Gastros\Desktop\Nützliche Dokumente 59 mm 25 mm 120 mm 140 mm Seitenansichten Ext.Bedieneinheit Downloaded from www.Manualslib.com manuals search engine...
Gastros erklärt hiermit, dass die oben erwähnten Produkte den unten gekennzeichneten Richtlinien – einschliesslich deren zum Zeitpunkt der Erklärung geltenden Änderungen – entspricht: Gastros herewith declares that the products mentioned above is in conformity with the applicable requirements of the following documents: EN 55011:2009 + A1:2010 EN 55014-2:1997 + Corr.1997 + A1:2001 + A2:2008...
Any information about our products are correct at time of publishing. Differnces in colour and shape of pictures, errors and printing errors are excep- ted. Subject to change without prior notice. InductWarm and the InductWarm logo are registered trademarks of Gastros Switzerland AG.