Ayce GG6380E Originalbetriebsanleitung Seite 58

Connecting electrical devices
AC power
1. Start the engine.
2. Make sure the appliance is turned off before connecting it to the generator.
3. Set the breaker to "ON".
current.
CAUTION: make sure that the appliance being connected is in good working order, if
it begins to act abnormally or stops suddenly, disconnect it from the generator.
CAUTION: make sure the appliance does not exceed the maximum rated load for the
generator.
CAUTION: any device with contains an inductive load e.g. devices that contain a motor
may require more current on startup.
DC power
1. Start the engine.
2. Set the breaker to "ON"
3. Connect the DC cable to the DC output.
(-) terminal of the equipment you would like to use.
DC overload protector
If the DC overload protector activates, wait for a few minutes and then press the
reset button shown on the right.
Shutting down the generator
1. Disconnect all appliances connected to the generator.
2. Set the breaker to "OFF".
114 115 GB