Herunterladen Diese Seite drucken

CORNING UCAO Montageanweisung Seite 2

Kabel-zugabfangung für sst-dropkabel und minikabel

Werbung

3. Montage SST-Dropkabel
3.1 Kabelmantel auf der benötigten
Länge absetzen und die beiden
Zentralelemente auf ca. 25 mm ein-
kürzen.
3.2 Die Zentralelemente, wie darge-
stellt, bis zum Anschlag unter die
Zentralelement- Zugabfangung schie-
ben und festziehen.
Das Kabel mit einem großen Kabel-
binder, wie dargestellt, sichern.
Entsorgungshinweis
Die örtliche und aktuell gültige Gesetzgebung ist bei der
Entsorgung der Produkte und deren Verpackung unbedingt zu
beachten!
Haftungsausschluss
Die Corning Cable Systems GmbH & Co. KG haftet nicht für
Schäden, die durch den nicht bestimmungsgemäßen Gebrauch des
Produktes entstehen.
Im einzelnen ergibt sich der Haftungsumfang aus
den Allgemeinen Verkaufsbedingungen der
Corning Cable Systems GmbH & Co. KG.
Dieses Produkt entspricht dem heutigen Stand der Technik!
Corning Cable Systems GmbH & Co. KG
© Corning Cable Systems GmbH & Co. KG,
Profilstrasse 4, D-58093 Hagen
++ 49-2331-357-0 Fax: 357-1118
Internet: www.corning.com/cablesystems
25mm
ucao_0105
ucao_0108
Disposal Note
Disposal of the products and their packaging must be carried out in
strict compliance with the local laws currently in force.
Disclaimer
Corning Cable Systems GmbH & Co. KG accepts no liability for any
damage arising from improper use of the product.
The extent of any liability in specific instances shall be limited to the
General Terms and Conditions of Sale from Corning Cable Systems
GmbH & Co. KG.
This product is state of the current art.
Gedruckt in der Bundesrepublik Deutschland auf sauerstoffgebleichtem Papier.
Printed in the Federal Republic of Germany on oxygen-bleached paper.
Liefermöglichkeiten und technische Änderungen vorbehalten.
Subject to availability. Right of modification reserved.
Best.-Nr.:
S45754-A3-P432
Order No.:
08.10. 2008
3. Installation of SST drop cable
3.1 Strip cable sheath to the required
length and trim both central elements
to approx. 25 mm.
3.2 Push the central elements as far
under the central elemet strain relief as
they will go, then tighten as shown.
Secure the cable with a large cable tie
as shown.

Werbung

loading