Important Safety Advices - AKE BT-HC4 Handbuch

turned on only after the engine is started . In this case, connect the supply
of electronics to 12 V connection of the headlight.
No Bluetooth connection after switching of fand on again:
Before reconnecting the power, always wait about 4 seconds until the log
out of the Bluetooth Helmet Connector is completed. Otherwise, it is
possible that it takes up to two minutes to reconnect or that the reconnec-
tion fails.
Audio signal from the radio, etc. overdriven at higher speeds:
Adjust Bluetooth helmet set to high volume and reduce the volume of
accessories and intercom accordingly.
Minimal Bluetooth noise in resting mode :
The Bluetooth-to-helmet connections are optimized for distortion-free
operation at high speed. Therefore, it's possible to hear fundamental
noise when engine is off (dynamic range).
No Duplex / Stereo switching or unexplained malfunctions:
If the Bluetooth devices get mixed up, please turn them off and on again.
Vehicle disturbance when Bluetooth helmet connector with own power
line is used:
Disconnect Bat.neg.-pole or use disturbance free power with AKE Power
Stabilizer.
17