Installation On The Vehicle; Pairing Of The Bluetooth Devices; Pairing A Second Helmet - AKE BT-HC4 Handbuch

4. Due to shadowing effects or interferences, it is possible that the range
might be considerably reduced. Therefore, we do not recommend
installing Bluetooth modules directly under the gas tank
5. With the use of several Bluetooth modules, we recommend to assem-
ble them separatly from each other. At close ranges (less than approx.
50 cm) Bluetooth devices might interfere with each other (click noise)

Installation on the vehicle

Connect the power supply to the active on board power system
(clamp 30, light- or accessory power) or via a 12 V switch, this is
best done by an expert. Not required with AKE PowerCom.
Plug-in Version: Plug into the jack for the helmet connection of
the bike and ready to use.
commend plug-in version so that the radio signals are not shielded.

Pairing of the Bluetooth devices

If the devices are already paired, you can ignore this chapter.
Turn the AKE Bluetooth Helmet off and on again with the operating button.
Hold down the button when switching on until the pairing mode is signaled
by rapid alternate blinking of the LEDs.
Hold your Bluetooth helmet or helmet set close to the
Helmet Connector and make sure that no other Bluetooth device in the
area is ready for pairing. Now quickly get your Bluetooth helmet or your
Bluetooth Helmet Set also into pairing mode for Bluetooth devices, e.g. cell
phone (ATTENTION: Do not use the Intercom pairing and do not try to pair
the Bluetooth helmet with the Harley Boom!™ Box). After a successful
pairing you will hear a short confirmation signal in the paired helmet and
the LEDs stop flashing alternately.

Pairing a second helmet

(Only possible with HC for Two). First pair the pillion's helmet, activate the
14
Build-in Version: Should be
assembled by a specialist. Assembly
leads are found on our website.
We recommend testing the combina-
tion before installation, for lack of gua-
rantee that all Bluetooth devices are
compatible. If the LEDs flash, the BT-HC4
is in operation. In metal covers, we re-
AKE
Bluetooth