Troubleshooting Guide - Braun MultiQuick 5 Vario Gebrauchsanweisung

Troubleshooting Guide

Problem
Hand blender does not
operate.
Mixing container is
leaking
Blending not properly,
stuck blade or speed
too low
Blade assembly cannot
be unscrewed
16
Potential causes
No power
Blade assembly not
correct in place or
worn out
Blade assembly is not
screwed properly to
the Mixing container
Mixing container is
overfilled
Big pieces of very hard
stuff blocking the
blade
Warm ingredients were
processed
Solution
"Check appliance is plugged in.
Check the fuse /circuit breaker in your home.
If none of the above contact Braun Service."
Check if Blade assembly is assembled properly and not
damaged
Check the position of the Blade assembly
Check maximum quantity recommendation
"Stop blending immediately, remove motor part from
the Blade assembly and remove blockage before
proceeding"
"Follow the recommendations for the correct order of
the ingredients, hard stuff on the bottom of the bottle"
"Cut hard stuff into small pieces before blending"
Follow recommendation to first start the motor and then
turning around the appliance for blending
Dip Mixing container in warm water