Error Message; Troubleshooting - Schartec Move 600 Montage- Und Betriebsanleitung

Error Message

No response from the garage
door operator.
System learning will not start.
Automatic closing cannot be set.
Opener opens and closes by
itself.
Opener does not work.
Garage door only opens.
Garage door does not close.
Garage door automatically
moves back 15-40 cm instead of
closing completely.
Remote control does not work.
Possible Cause
1. There is no power.
2. Plug not inserted.
Photocell connected incorrectly or is
not recognized by the motor.
Photocell not connected.
Interference pulse / mounting next to
the power line.
End position open or closed set
incorrectly.
When using a photocell or when
activating the photocell function
without a connected photocell.
Automatic safety return. Because of
an old and incorrectly set garage
door. Door not balanced or springs
old, weak or defective.
1. Battery is empty.
2. Interference source in the area.
47

Troubleshooting

1. Check the voltage at the socket of the door
operator.
2. Carefully open the cover of the motor and
check whether all cables are connected.
1. Check the connection of the photocell.
2. Adjust the photocell correctly.
Connect the photocell. This function is only
possible with a connected photocell.
The motor must not be installed in the immediate
vicinity of a power line (electrostatic charging).
Reset the end positions as described in the
instructions.
1. Check the photocell and make sure that no
obstacle interferes with it.
2. Deactivate the photocell function if no
photocell is installed. To do this, follow the
instructions.
1. Check the springs in every door position
2. Reset the end positions.
3. Increase the power for automatic reversal.
1. Replace the battery.
2. Remove all sources of interference in the
area (e.g. baby monitors, etc.).