Revox ZUMTOBEL Re:sound I Z60 Bedienungsanleitung Seite 24

Re:sound I – Z60
INSTALLATION
Step 2
-4
Insert the fitted speaker into the open-
ing and tighten the 2 rotary tensioner
screws (with provided Allen key 3.0
mm) clockwise a little, until the
speaker flange is held in position at
the sides.
Step 3
-4
You should carry out a sound test
before installing the front plate, in
order to check that the installed
speaker is functioning correctly.
Info
The Re:sound I speaker has an inte-
grated rotary tensioner to enable
quick installation. These rotary ten-
sioners are located on the rear of the
speaker and swivel out through 90°
once the 2 marked screws on the
front of the speaker are screwed in.
Test
21
21