Herunterladen Inhalt Inhalt Diese Seite drucken

Tecsis EGS08 Betriebsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Betriebsanleitung/Operating manual
EGS08
Configuration possiblilities
The solder bridges P1 to P10 serve to configure the circuit and thus adapt it to the
concrete application case.
Bridge
P1
P2, P3
P4
P5
P6
P7
P8
P9
P10
18
Function
open
closed
Signal damping
measurement
input
Load resistance
Hysteresis
comparator 1
Hysteresis
comparator 2
Hysteresis
comparator 3
Switching relay 1
Switching relay 2
Switching relay 3
Function
Alternating current power supply
Direct current power supply
(only necessary when GND on X2-2 and
GND X1-2 must have the same potential)
P2=open P3=open/
weak damping (10k , 0.1µF)
P2=open P3=closed/
medium damping (10k , 10.1µF)
P2=closed P3=closed/
strong damping (10k , 20.1µF)
open 360
closed 180
open 20 mV
closed 70mV
open 20 mV
closed 70mV
open 20 mV
closed 70mV
open – relay drops out on exceeding the
threshold
closed – relay closes when the threshold
is exceeded
open – relay drops out on exceeding the
threshold
closed – relay closes when the threshold is
exceeded
open – relay drops out on exceeding the
threshold
closed – relay closes when the threshold
is exceeded
BD_BE 989 e
www.tecsis.de

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis