Tecsis EGS08 Betriebsanleitung Seite 17

Betriebsanleitung/Operating manual
EGS08
Fig.: characteristic curve of the sensor with calibration check
Measuring points and terminal X3:
On the printed circuit board there is a 6 pole socket terminal strip "MP" to check the
function of the force transducer and the setting values. A plug with the same pin
allocation is provided for the connection of a service instrument.
Terminal
1
2
3
4
5
6
The measurement voltage is picked up from a working resistance of 360
1-9mA sensor or 180
damps the signal from the sensor and makes it available to the measuring point
and the comparators.
www.tecsis.de
Signal
UB ( 5V )
GND
Measuring voltage
Setting value POT1
Setting value POT2
Setting value POT3
with a 4-20mA sensor. A deep pass that can be configured
BD_BE 989 e
with a
17